WIPER MOTOR ADJUSTMENT

From an article in the Essex A7 Owners Club with many thanks

After the vacuum driven wiper motor, a strange electrical device was fitted to Austin 7s which used a pulse motor to drive the wipers. In this type of motor there is no continuous flow of current through the coils of the armature (that sausage bit in the middle that spins round, the same as in a dynamo) but a contact breaker (very similar to the one in the distributor) which puts a pulse of current into the coils around the armature creating a short pulse of magnetism. This rotates the armature sufficiently that the contact breaker closes again and puts another pulse into the armature. To set all this going, the driver spins the armature by hand using the on/off knob. Once running the wiper motor keeps spinning, or rather should do.

If there is insufficient power in the pulse to keep the armature moving for an additional quarter revolution the whole thing stops.  The two normal causes are either the contacts of the contact breaker are dirty or they are incorrectly adjusted

So how do we go about keeping the wiper running smoothly?

Firstly we need to make sure that the contact breaker points are clean.  They open and close four times for every revolution of the armature which, in turn, revolves many times for each sweep of the wiper arm. Clean them with a little slip of fine abrasive paper between the points. If you turn the armature so that the points are open, there is enough room for a slip of emery paper. Whilst the paper is between the points, rotate the armature a little so that the points close a little and then drag the paper from between the points. Don't be too rough, they are quite delicate. You will notice that the contact close to the cam on the armature is attached to a leaf spring which in turn is attached to two posts by small screws. This can be carefully removed if the points are in bad condition and the surface of the points can be carefully cleaned up. It's a bit fiddly so it is actually better to leave it all in place.

Once you have cleaned the contacts, connect the motor to a power supply, loosen the adjusting screws and slide the whole Bakelite (see arrows on diagram opposite) plate so when the armature is spun it rotates freely and at its maximum speed. Lock the two adjusting screws when you are happy with the setting.

A little lubrication on the cam (very little) will help, as will adequate grease in the gearbox under the wiper motor which is accessed by removing the plate underneath the motor as it appears in the picture.